New Cisco 300-360 dumps practice questions on sale, pass Designing Cisco Wireless Enterprise Networks. With the complete collection of questions and answers, Pass4itsure has assembled to take you through 60 Q&As to your 300-360 exam preparation. Getting the Cisco https://www.pass4itsure.com/300-360.html dumps study guide for preparing the Designing Cisco Wireless Enterprise Networks dumps is the best option for the candidates. It needs extreme expert choice along with great proficiency.
Exam Code: 300-360
Exam Name: Designing Cisco Wireless Enterprise Networks
Q&As: 60
Pass4itsure Cisco 300-360 Dumps From Google Drive https://drive.google.com/open?id=0BwxjZr-ZDwwWRzV4WUQyeVN2N2c
Pass4itsure Microsoft 70-743 Dumps From Google Drive https://drive.google.com/open?id=0BwxjZr-ZDwwWeGVCOE9QRi1EaWs
Cisco Exam Pass4itsure 300-360 Dumps PDF Blog Series:
QUESTION 206:An analog signal's phase measures:
A. The number of volts from one peak to another.
B. The time required for the wave to go from peak to peak.
C. The relative difference between the peak of a signal wave and the peak of a reference wave.
D. The time required for the wave to move along the channel.
300-360 exam Answer: C
QUESTION 207:
A transmitting modem sends a carrier signal to a receiving modem. The purpose of
the carrier signal is to:
A. Carry the transmission over the network.
B. Establish the bps rate for the transmission.
C. Carry information about the packets to the receiving modem.
D. Alter the frequency, amplitude, and/or phase of the transmitted signals.
Answer: A
QUESTION 208:
You are sending data over the network and your modem has a maximum speed of
300 bps. What modulation technique is most likely being used?
A. FSK
B. KHZ
C. QAMD. DPSK
300-360 dumps Answer: A
QUESTION 209:
Your modem uses the ITU V.32 modem protocol. This modem modulates the signal
by using 1 of 16 different combinations of phase and amplitude. What modulation
scheme is being used?
A. FSK
B. QAM
C. KBPS
D. DPSK
Answer: B
QUESTION 210:
In a digital data communication network, the CSU/DSU receives the signal from the
DTE and converts it into what type of signal format?
A. FSK
B. QAM
C. Line code
D. Equalized
300-360 pdf Answer: C
QUESTION 211:
What type of line coding is used by most digital communications systems?
A. FSK
B. QAM
C. Bipolar
D. Unipolar
Answer: C
QUESTION 212:
To maintain synchronization between a sender and a receiver, digital data transmission relies on:
A. Specialized clocks on the receiving end.
B. Continuous voltage within the bit stream.
C. A completely digital transmission channel.
D. Frequent changes of voltage within the bit stream.
300-360 vce Answer: D
QUESTION 213:
A multiplexer is considered what type of communications equipment?
A. DTE
B. DCE
C. CSU/DSU
D. DTE interface
Answer: A
QUESTION 214:
A data transmission is using a multiplexer. The multiplexer assigns each channel to
one or more time slots based on the channel's requirements. What multiplexing
method is being used?
A. Statistical
B. Manchester
C. Time-division
D. Frequency-division
300-360 exam Answer: C
QUESTION 215:
In a call center, what is calling number ID (CLID) used for?
A. To identify the called party
B. To control the application software
C. To identify the calling party
D. To automatically bill the caller
Answer: C
QUESTION 216:
What does CTI involve?
A. Connecting a single workstation or a LAN server to a telephone switch so that thecomputer can manage voice calls.
B. Connecting telephones to computers in order to transfer data.
C. Integrating computers, modems, and fax equipment on the same telephone line.
D. Integrating telephone switching to accommodate data and voice on the same lines.
300-360 dumps Answer: A
QUESTION 217:
Which of the following statements most accurately describes predictive dialing?
A. This system is programmed to dial numbers and connect the called party to a
telephone services representative.
B. This system answers a company's telephones.
C. This system translates spoken language into data for entry in computer databases and other applications.
D. This system manages incoming telephone calls to route them to the appropriate
service representative.
Answer:
Here, candidates can get Cisco 300-360 dumps questions that are prepared by the expert faculty. This study guide is designed for free 70-767 dumps. Choose the most eligible site that offers the services of for all type of Cisco 300-360 dumps test questions.
It is quite obvious that passing this Designing Cisco Wireless Enterprise Networks. dumps is not a simple piece of https://www.pass4itsure.com/300-360.html dumps paper writing.
Read More: http://www.bdexams.com/free-cisco-300-360-dumps-widesign-study-guide/
Read More Youtube: https://youtu.be/e9nMO3A00RE
No comments:
Post a Comment