Complete the question and answer Cisco 200-401 pdf dumps free download
[PDF] Cisco 200-401 pdf dumps free https://drive.google.com/file/d/1QwqV1fORoevAdZ2uUswNdDklxAn6D8Xu/view?usp=sharing
Practice | Cisco 200-401 Exam Questions
QUESTION 1
At which Layer would you troubleshoot a cabling issue?
A. Layer 1
B. Layer 2
C. Layer 3
D. Layer 4
Correct Answer: A
QUESTION 2
You are a called upon to troubleshoot connectivity problems to a network device on a production floor. You have used
ping and traceroute to verify that you cannot connect to the device from the management network. The network is
209.165.202.128/27 and the device has been given the IP address 209.165.202.158 and mask 255.255.255.224. You
have verified that you can reach the device with your computer connected to the same switch as the device. What could
be the cause of this problem?
A. The device is set to the wrong subnet mask.
B. The device is set to the wrong IP address.
C. The device has no IP default gateway.
D. The device is connected to a switchport in the wrong VLAN.
Correct Answer: C
QUESTION 3
Which two reasons make mesh bonding systems most effective? (Choose two.)
A. cover wide areas
B. provide additional strength to floor structures
C. provide low-impedance noise-equalizing paths
D. create equipotential grounding systems
E. most cost-effective approach
Correct Answer: CD
QUESTION 4
What should be done with unused conductors in copper unshielded or shielded twisted-pair network cables?
A. terminate in their characteristic impedance
B. trim back and properly insulate
C. connect to protective earth
D. splice to a used conductor
Correct Answer: A
QUESTION 5Which option allows an EtherNet/IP I/O device to be safely installed where it is subject to water immersion?
A. The device is rated IP20 and the power wiring is installed securely to the terminal block.
B. The device is rated IP67 and a power cordset is used.
C. The device is rated IP67 and immersed to 10 m.
D. The device is rated IP20 and immersed to 10 m.
Correct Answer: B
A. The device is rated IP20 and the power wiring is installed securely to the terminal block.
B. The device is rated IP67 and a power cordset is used.
C. The device is rated IP67 and immersed to 10 m.
D. The device is rated IP20 and immersed to 10 m.
Correct Answer: B
Latest discount code sharing | Pass4itsure
https://www.pass4itsure.com/200-401.html provides the latest and valid Cisco 200-401 exam dumps for your exam preparation and help you pass your exam successfully.
No comments:
Post a Comment